Bob Pearson · Workshop journal

Workshop resource · 1 / 3

Blueprint & measurement plan

BP–MS01 · Sheet A: footprint / front elevation · Planning schematic, not to scale.

24322424 in deepLEFT WINGCENTERRIGHT WINGDashed: ~30 in saw envelope; locate by actual sawFence segments stop short of the saw’s full miter/bevel sweep.32 + 24 + 24 = 80 in of panel width; backers add 3 in.Allow about 83 in + bracket offsets / working gaps. Not to scale.24 in wing32 in center24 in wing~37 inSAW MOUNTING DECKOpen storage belowSaw-table datumSCHEMATIC · hardware and clearances set final span

Dashed front datum represents the saw table, not an additional platform. Center deck is lower by S. Backers add 1½ in at each end; hinges, gaps and folded fence projection are hardware-dependent.

Workshop resource · 2 / 3

Blueprint & measurement plan

BP–MS01 · Sheet B: frame / vertical stack · All dimensions in inches.

H = desired saw-table height (~37 in)S = confirmed table offset (~3 9/16 in)T = actual plywood deck thicknessL = leg length — do not cut yetB = entire reinforcement stackFlat 2×4 + plywood cap (nominal 2¼ in)C = actual caster overall heightFloor to underside of mounting padL = H − S − T − B − C · rails sit within the leg height32 in overall24 in29 in rail29 in rail17 in side railsLEG SECTION1½ in across width3½ in front-to-backRails stand on edge:3½ in tall.Top view · identical upper and lower rail setsDeck removed for clarity · nominal 2×4 is 1½ × 3½ in

Caster pad: pair two 7 in flat 2×4 blocks, cap beneath with 7 × 7 in plywood. Nominal stack B = 2¼ in. Actual plate fit, hole spacing and rail-side-grain attachments must be checked before drilling.

Workshop resource · 3 / 3

Blueprint & measurement plan

BP–MS01 · Sheet C: release-to-cut worksheet

Saw model / type: __________________
Caster model / plate size: __________________
H · desired cutting height: __________
S · confirmed table offset: __________
T · actual deck thickness: __________
B · assembled pad thickness: __________
C · caster overall height: __________
L = H − S − T − B − C: __________
Bracket model / backer size: __________
Wing underside H − wing thickness: __________
Final rear brace opening: __________
Actual open / folded width: __________

Fit checks before drilling

Measured by: __________________   Date: __________________

This is a proposed custom woodworking arrangement, not an engineered load-rated drawing. Hardware patterns and working clearances must be transferred from the actual components. Do not scale holes from the diagrams.